Latest in AI
SageMaker HyperPod Global Inference Gateway: Check Each Cluster Before Moving Clients
Plan a HyperPod gateway migration around EKS readiness, local model schedulers, load metrics and a reversible client cutover.
A single inference URL removes some work from clients. It doesn't make every cluster behind that URL ready to serve the same model. The first thing I'd test with SageMaker HyperPod Global Inference Gateway is whether a model can actually run on every cluster that's supposed to take its traffic.
AWS introduced the gateway on November 20. This is the cluster routing option for HyperPod Inference, not the SageMaker inference router for managed endpoints or inference components. If clients already call a managed endpoint, this guide describes a different deployment architecture, not a different URL for the same endpoint.
Know which gateway makes which decision
Your client names the model in its request. The global gateway selects a member cluster. The in-cluster Inference Gateway and its model scheduler then select a serving pod. Adding the global layer doesn't configure the model scheduler for you.
For a two-cluster pilot, put one small model behind both local gateways. Write down the model name that clients pass and make sure it matches the scheduler's configured model name in both clusters. Verify the checkpoint, tokenizer and serving settings separately. A shared name makes the model routable from one endpoint; it doesn't make two deployments equivalent.
Check the prerequisites on every cluster
The AWS setup guide requires EKS-orchestrated HyperPod clusters in the same AWS account and in supported Regions. It specifies HyperPod Inference add-on v3.0.0-eksbuild.1 with the in-cluster gateway enabled, AWS Load Balancer Controller and cert-manager. The console's Quick Install adds cert-manager, but a CLI setup needs it installed separately.
AWS lists vLLM v0.9.2 or later, or SGLang v0.3.5.post1 or later with --enable-metrics. A cluster needs to report KV cache utilization and queue depth to receive traffic. Serving a request directly from a pod isn't proof its load is visible to the global gateway.
Keep a readiness record per member: region, configured model name, add-on version, direct inference result and whether the expected metrics arrive. That makes it easier to distinguish a deployment issue from a routing issue.
Verify readiness in stages
After the infrastructure team publishes each in-cluster gateway, check that its global routing status is Ready. Next check that the global resource has ACTIVE status and an endpoint URL, each member is active, and each member's metrics publisher is ready. The metrics publisher doesn't start until the member is added to a global gateway.
Run a request through the shared endpoint with the intended model name. Test both regular and streaming requests if your client uses both. AWS documents SigV4 and IAM authorization, with a separate invocation action for streaming. A client that sends an OpenAI-compatible body still needs the required AWS authorization.
Test failover without promising an uninterrupted stream
Use a staging client and watch where requests are served. Record the healthy path, then exercise a planned member removal. Compare new requests separately from those already running. AWS says removal stops new requests to that member and allows in-flight requests to finish.
That's different from losing a member unexpectedly. AWS describes retrying a failed request once on another cluster unless it has already started streaming. Test recovery in the client rather than expecting a partial stream to continue elsewhere. Check that the remaining member can handle the pilot's traffic.
Move one caller and keep the old route
The gateway fleet runs in the Region where you create the gateway. Routing across supported Regions doesn't prove that the regional entry point will always be reachable. If you have a regional availability requirement, evaluate that entry path separately from member failover.
Move one internal caller first and keep its old cluster endpoint available for rollback. Compare response behavior, errors and latency under the same traffic. A useful cutover is one where you can explain both where the request went and what you would do if it stopped arriving.
I'm Paras. I work at the intersection of AI, engineering and distribution.
I help AI teams explain technical products through clear documentation, practical guides and developer-focused content.